![Wingauge's widths and extents pane.](images/Widths_and_Extents_Pane_01.png)
The Widths and Extents pane lets you set the shape and location of the needle marker on your Linear or Radial gauge.
Widths — Customize the shape of your needle by specifying the following values:
Start — Set this value to an integer from 0 to 100. This value sets the width of the start point of the needle marker.
Mid — Set this value to an integer from 0 to 100. This value sets the width of the midpoint of the needle marker.
End — Set this value to an integer from 0 to 100. This value sets the width of the end of the needle marker.
Extents — This section determines the location of the needle marker. In a Radial gauge, this position is measured from the center, and in a Linear gauge, this position is measured from the bottom of the gauge.
Start — Set this value to an integer from 0 to 100. This value sets the position of the start point of the needle marker.
Mid — Set this value to an integer from 0 to 100. This value sets the position of the mid-point of the needle marker.
End — Set this value to an integer from 0 to 100. This value sets the position of the end point of the needle marker.