Version

Widths and Extents Pane

The Widths and Extents pane lets you set the shape and location of the needle marker on your Linear or Radial gauge.

Widths — Customize the shape of your needle by specifying the following values:

  • Start  — Set this value to an integer from 0 to 100. This value sets the width of the start point of the needle marker.

  • Mid  — Set this value to an integer from 0 to 100. This value sets the width of the midpoint of the needle marker.

  • End  — Set this value to an integer from 0 to 100. This value sets the width of the end of the needle marker.

Extents — This section determines the location of the needle marker. In a Radial gauge, this position is measured from the center, and in a Linear gauge, this position is measured from the bottom of the gauge.

  • Start  — Set this value to an integer from 0 to 100. This value sets the position of the start point of the needle marker.

  • Mid  — Set this value to an integer from 0 to 100. This value sets the position of the mid-point of the needle marker.

  • End  — Set this value to an integer from 0 to 100. This value sets the position of the end point of the needle marker.

Wingauge's widths and extents pane.